Belt conveyor running belt deviation is the most common fault.
In order to solve the dimensional accuracy of such failures is important to note the installation and day-to-day maintenance. There are many reasons for deviation, need to be dealt with according to the different reasons difference. Adjust the carrying belt conveyor idlers belt adjustable roller position of the group in the middle of the entire belt conveyor deviation to adjust the deviation; growth hole mounting holes on both sides of roller group are processed at the time of manufacture, in order to be adjusted. Specific adjustment method, the specific method is the belt deflection which side of the the idlers which side toward the belt forward direction forward, or the other side shift. Shown in Figure 1 belt upward direction of deviation of the roller group at the next bit should move to the left, move to the right at the upper idlers. Installation aligning idlers aligning idlers There are many types such as center pivot four-bar linkage, vertical roll, etc. The principle is blocked or roller direction in the horizontal plane rotation stopper or lateral thrust The belt is automatically adjusted to the heart reaches the purpose of the belt deviation. Generally shorter total length of the belt conveyor or belt conveyor run in both directions using this method is more reasonable, because the the shorter belt conveyor easier deviation and difficult to adjust. Long belt conveyor is best not to use this method, because the life of the belt aligning roller group will have some impact. Adjust the drive roller and the drive roller and bend pulley adjustment bend pulley position is an important part of the belt deviation adjustment. Because a belt conveyor with at least 2 to 5 rolls, all the mounting position of the drum must be perpendicular to the longitudinal direction of the belt conveyor centerline bound deviation occurs, if the skew is too large. The adjustment method is similar to the adjustment idlers. Head drum, such as a belt deviation to the right side of the drum, the right side of the bearing housing should be moved forward, the belt deviation to the left side of the drum, the bearing housing on the left side should be moved forward relative should also be the left shift or right side of the bearing housing bearing after shift. Rear roller adjustment method and the head drum is just the opposite. Adjustment method. After repeated adjustment until the belt is transferred to a more ideal location. Best adjust the drive or bend pulley install its exact location. 4. Tension at adjusting the belt tension at the adjustment is a very important part of belt conveyor deviation adjusted. http://www.zm-automation.com
Liked by:
playgrounds